Bad Boy Q0378, Operator'S Manual

Page: 12 / 22

12
2-17 Installation/Removal Of Collection
Bags
To install the bag P#(G0004) onto the bag ring
P#(B0227), first make sure the bag ring end caps
P#(J0274) are fastened to the bag ring. Place the seam
openings of the bag onto the bag ring openings and turn
the bag until the slot bracket in the bag ring is protruding
from the opening in the bag (Figure 2-17a). Do this for
both bags.
Install the completed assemblies onto the support frame
and close the plastic top. To secure the plastic top while
in use, fasten the rubber strap with S hook to the right
pivot side rail as shown in Figure 2-17b.
To empty the bag, remove the bag and bag ring by
sliding the bag rearward. Grasp the loop on the bottom
of the bag, turn it upside down and empty the collected
debris (Figure 2-17c). Repeat for the other bag. Reinstall
both bags, line with plastic bags if desired, close the
plastic top and reattach the rubber strap with ‘S’ hook.
Plastic lawn and leaf bags, 33 gallon size, may be used
inside the cloth bags. Be sure to leave enough plastic
bag hanging over the frame so the plastic bags can be
twist tied before emptying (Figure 2-17d).
Figure 2-17a
Cloth Bag
Seam
Opening
Bag Ring
Bag Ring
End Caps
Figure 2-17c
Figure 2-17d
Grasp Bag
Here
Plastic Bag
Cloth Bag
Figure 2-17b
Rubber Strap
With Hook
Plastic
Top
Right Pivot
Side Rail