Bad Boy MZ Series, Owner'S Manual

Page: 22 / 44

SECTION 5: FRAME
Torque rear wheel lugs to 65-75 ft. lbs. Retorque at every oil
change. (All models)
There is one grease fitting on each of the actuator bar pillow
blocks (Total of 4). Grease twice a season.
The pump belt tensioner is located under the engine and has
a grease fitting at its pivot point. Grease at every engine oil
change.
The deck belt tensioner is located at the rear of the deck and
has a grease fitting on its pivot point. Grease at every engine
oil change.
The control arm blocks have grease fittings located on the
top of each block. Grease one time a year.
Grease fittings on MZ model total – 9
SECTION 6: CUTTING DECK
To remove the deck belt, lift up on the belt while rotating the
pulley to roll the belt up and off of the pulley. (be sure not to
get your fingers between belt and pulley). To check the level
of the deck, start on a flat surface and set the air pressure in
all four tires. Raise the deck up, and measure all four corners
of the deck to see if it is level from left to right and front to
back. All decks should be level from left to right and have a
1/8” pitch down in the front.
PAGE 22