Bad Boy COMPACT OUTLAW, Owner'S, Service & Parts Manual

Page: 22 / 60

SECTION 3: ENGINE
PAGE 19
810cc Vanguard
This machine has an oil drain hose installed on the
engine to allow for easier oil changes. Bad Boy
recommends that the oil and filter be changed at
intervals of 50 usage hours or yearly, whichever
occurs first. The oil capacity is 2 quarts. Bad Boy
10W-30 synthetic blend engine oil is recommended for
maximum protection.
3.1 Changing your engine oil and oil filter
1) Remove oil dipstick and open oil drain. Allow
oil to completely drain. (Make sure to have an
oil pan ready to capture old oil and properly
dispose old oil.)
2) The oil filter is located on the right side of the
engine. Clean area around oil filter. Place a
container under the oil filter to capture any oil
and remove filter. Wipe off mounting surface
and reinstall drain plug. Torque to 10 ft*lb.
3) Place new filter in shallow pan with open end up. Fill
with new oil until oil reaches the bottom of the
threads. Allow 2 minutes for oil to be absorbed by
filter material.
4) Apply a thin film of clean oil to rubber gasket on new
filter
5) Refer to instructions on oil filter for proper installation.
6) Fill crankcase with approximately 2 quarts of new oil.
Level should top of indicator on dipstick.
7) Reinstall oil fill/dipstick and tighten
securely.
8) Start engine; check for oil leaks. Stop Engine; correct
oil leaks. Recheck oil level
9) Dispose of used oil and filter in accordance with local
ordinances.