Step 1: Locate Part A and Part B. Connect Part B to Part A by
inserting end of Part B onto swedge end of Part A aligning holes as
shown in (Diagram 1). Place a 13mm washer onto Part Q (2 ¾”
Bolt) and insert through both Part A & B (Box 1), Place a second 13
mm washer onto bolt and then a 13 mm lock nut (Box 2). Tighten
with the open ended wrenches (Part Z)
Box 1
Box 2
Box 3
Part A
Part B
S
T
E
P
1
Step 2: Locate Part D. Connect to Part B by placing Part B between
the metal flanges of Part D, and align the holes of the flanges with
the hole about halfway along Part B as shown in (Diagram 2). Place a
16 mm washer onto Part P (3 ½” double threaded bolt) and insert
through metal flange of Part D through part B, and the second metal
flange of Part D. Place another 16 mm washer on exposed end of
bolt, and then an acorn nut. (Box 4) Tighten with the two open
ended wrenches. (Part Z)
Diagram 1
Box 4
S
T
E
P
2
Diagram 2
Note: The connection of Part D
with B will still be loose after
tightening acorn nuts allowing
Part D (the leg) to swivel
slightly.
Step 3: Locate parts C and H. Slide part H onto Part C through the
O-bracket of Part H, from the base of Part C (Box 5) to just before
the attached hanging ring. (Box 6)
S
T
E
P
3
Box 5
Box 6
