Step 4: Locate Parts Y. Insert square nut into nut slot on bottom of O-ring of Part H, as shown in Box 7. Then insert hand
knob of part Y through the hole of part H as in Box 8. Straighten the Part H assembly so the hand knob is just below the
hanging hook as shown in Box 9, then tighten hand knob so Part H stays in place.
Box 7
Box 8
Box 9
S
T
E
P
4
Box 10
Box 11
Box 12
S
T
E
P
5
Part C
Part B
Step 5: Place bottom end of Part C over the swedge end of Part B as
shown in Box 10. Align holes of Part B and C and insert Part Q (2 ¾”
bolt with 13 mm washer) through hole until bolt shows through
opposite side of Part C as shown in Box 11. Place second 13 mm
washer onto end of bolt then the 13 mm lock nut. Tighten securely
using the open ended wrenches (Parts Z) as in Box 12.
S
T
E
P
6
Step 6: Find Parts E. Identify the ends with the crimp over the hole as
shown in photo. Hold both Parts E with crimps facing each other and
proceed to Step 7.
