Operating Instructions & Parts Manual
Ver. 2011-12-1
Page 15 / 27
3. Pull up on the foot pedal to release the brake.
4. Push the machine.
Result: The machine should move
.
Test the Winch Operation
Note: The model STD-227, BR-227 and BC-227 does not have an inner frame.
1. Rotate the winch handle clockwise to raise the carriage.
Result: The carriage should raise to the top of the inner frame and then the inner frame should raise. The
carriage and inner frame should move smoothly, free of hesitation and blinding.
2. Rotate the winch handle counterclockwise to lower the carriage.
Result: The inner frame and the carriage should lower into the outer frame. The carriage and inner frame
should move smoothly, free of hesitation and binding.
Workplace Inspection
Do Not Operate Unless:
You lear
n and practice the principles of safe machine operation contained in this operator’s manual.
1. Avoid hazardous situations.
2. Always perform a pre-operation inspection.
3. Always perform function tests prior to use.
4. Inspect the workplace.
Know and understand the workplace inspection before going on to the next section.
5. Only use the machine as it was intended
Fundamentals
The Workplace Inspection helps the operator determine if the workplace is suitable for safe machine
operation. It should be performed by the operator prior to moving the machine to the workplace.
It is the operator’s responsibility to read and remember the workplace hazards, the watch for and avoid
them while moving, setting up and operating the machine.
Be aware of and avoid the following hazardous situations:
·
Drop-offs or holes
·
Bumps and floor obstructions
·
Debris
·
Overhead obstructions and high voltage conductors
·
Hazardous locations
·
Inadequate surface support to withstand all load forces imposed by the machine
·
Wind and weather conditions
·
All other possible unsafe conditions
