BACA SYSTEMS EDGE XL, Operation Manual

Page: 28 / 52

8/15/2019
28
5. The 3 buttons below operate the laser:
a. The laser button on the left is used to calibrate the laser. Place the laser reflectors
in the table before clicking this button. Then watch the laser scan the reflectors.
Make sure all 4 reflectors are scanned. If all 4 reflectors are not scanned, check to
make sure the reflectors are clean.
b. The laser button in the middle will display the vacuum pods on the table.
c. The laser button on the right will display the pieces on the table.
6. The speed of the machine can be controlled using either the -/+ keys, the slider bar, or
by clicking on the number you can type in a new number. The number represents
federate percentage. The example below show 100% federate.
7. The START button will start the program, as long as the machine is in automatic mode.
8. The STOP button will pause the program from running.