WWW.BALTIMOREAIRCOIL.COM
16
Bracket Mounted Assembly: PFi-1012, 1024, 2012, 1212, 2412, and 1224 (Two Fan
Only for PFi-1218, and1236) (Figure 24)
1. The upper mechanical section should already be secured onto the lower section. Verify
the mounting guides are factory installed. If these mounting guides are not factory
installed, please contact your local BAC Representative.
2. Apply foam tape (BAC part # 270567) to the bottom edge of the PCD hood. Lower the
PCD hood into position on the upper mechanical section by aligning the bolt
holes on the PCD hood with the pre-existing bolt holes on the bracket mounts as
shown in
Figure 24
. Be sure to follow the minimum height restrictions H found in
Table 3
between the top of the PCD Hood and the apex of the crane cables supporting
the load.
3. Secure the PCD hood using the 5/16” x 1” tappers provided.
Access Door
Mounting Clips
PCD Hood
Upper Mechanical
Section
Figure 24.
PCD Hood Bracket Mounted Assembly
Model Number
H (Distance From Lift
Point to Lifting Device)
PFi-0406
4’
PFi-0412
4’
PFi-0709
5’
PFi-0718
5’
PFi-1012, PFi-1024, and PFi-2012
8’
PFi-1212, PFi-2412, PFi-1224, and PFi-2424
8’
PFi-1218, and PFi-1236
8’
PFi-1218, PFi-1236, and PFi-2418
9’
Table 3.
PCD Hood Vertical Lift Dimensions
Figure 23.
PCD Hood Lift
H
WARNING:
Do not use the PCD
lifting ears to lift the mechanical
section or the unit.
