31
32
Copyright © 2023, Baby Trend, Inc.
Copyright © 2023, Baby Trend, Inc.
4. Route seat belt through forward facing
belt path (Fig. 31a).
5. Put weight in seat with hand to compress
the vehicle seat cushion then insert the
buckle tongue into the buckle and adjust
seat belt as tight as possible (Fig. 31b).
6. Pull seat fabric up and over the top of the
car seat. Then, install the pillow (Fig. 31c).
7. Pull up on buckle as to ensure the
buckle is secure. Please refer to the
vehicle owner’s manual to determine if
your vehicle lap/shoulder belt includes a
lockable retractor and how to lock it.
5.6 Forward Facing Installation with Lap Belt and Top Tether
Top Tether
8. Always attach Top Tether to a designated
anchor point. Pull Top Tether strap until
webbing strap is snug (Fig. 31d).
NOTE: Your vehicle owner’s manual will
give the anchor locations and maximum
weight of the car seat’s occupant for UAS
connections.
9. Check for movement of the car seat at the
safety belt path. The car seat should not
move more than 25.4mm (1 inch) in any
direction. If the car seat moves more than
25.4mm (1 inch) repeat all steps until all
safety steps are met.
Requirements. See section 2.2:
• Weight is 10.43 - 29 kg
(23 - 65 lbs)
• Height is 127 cm (50 inches) or less.
• Age is 1 year old.
1. Place the car seat in a rear seating position. Always adjust the
recline foot to the upright position when forward facing.
2. Ensure vehicle is level and that the car seat is placed and rests on
the front outer edge of the vehicle seat.
3. Loosen harness by pressing the center
adjuster and pulling on harness. Pull top
of seat fabric down to expose the forward
facing belt path (Fig. 32a).
5.0 Installation and Use
5.0
Installation and Use
Fig. 31a
Fig. 31b
Fig. 32a
Fig. 31c
Fig. 31d
