5
12. Attach the left side height bracket in the same manner as the
right. Secure the left side height bracket with
1 (3.5mm x 10)
screw.
13. Insert the front tube of the right side upper frame assembly
into the height bracket as shown in figure 12. The front tube
is easily distinguished from the rear tube by the array of holes
in the tube. Push the tube through the height until the height
bracket locks into the highest position. See figure 13.
14. Insert the front tube of the left side upper frame assembly into
the height bracket as shown in figure 14. Push the tube through
the height until the height bracket locks into the highest
position.
15. Insert the front leg into the ends of the front tube of both the
right and left upper frame assemblies as shown in figure 15.
16. Insert the rear leg into the ends of the rear tube of both the right
and left upper frame assembly as shown in figure 16.
17. Secure the legs to the upper frame assemblies with the 4
washers and screws as shown in figure 17.
18. Attach each of the casters to the high chair feet with the caster
pins provided as shown in figure 18. Tighten the pins until
snug: do not over-tighten. Check that all four casters are
securely fastened to the high chair. Casters with brakes can be
installed on front or rear legs.
Figure 12
Upper Frame
Assembly
Height
Bracket
Figure 14
Figure 15
Figure 16
Figure 13
Figure 17
Screw
Plastic
Washer
Foot
Caster
Caster
Pin
Figure 18
