8
5
FITTING THE SEAT UNIT TO THE CHASSIS (ATTACHMENT DEVICE)
The seat unit can be fitted to the chassis to face either forwards or
backwards. To fit the seat unit to the chassis, locate the retaining bars
found on the seat unit sides on the attachment device in the correct
position (see pictures 3 & 4) and gently push the seat unit until it clicks
into position. Check that the seat unit is securely attached by trying to lift
the seat unit from the chassis. DO NOT ATTEMPT TO FIT THE SEAT
UNIT WHILE IT IS OCCUPIED.
NOTE:
Backwards facing seat position. If the seat unit is fitted in the
wrong position the footrest will not fold down.
REMOVING THE SEAT UNIT FROM THE CHASSIS.
The chassis cannot be folded with the seat unit fitted
To remove the seat unit from the chassis release the attachment devices
on either side of the chassis. Pull the triggers at the bottom of the
attachment device until they stop and remain in position. When both
triggers have been released the seat unit can be lifted clear of the
chassis. DO NOT ATTEMPT TO FIT OR REMOVE THE SEAT UNIT
WHILE IT IS OCCUPIED. CHILDREN SHOULD BE CLEAR OF MOVING
PARTS WHILE MAKING ADJUSTMENTS.
FITTING THE BRITAX CAR SEAT & ADAPTOR
To fit the car seat to the chassis, first fit the adaptor. Locate the retaining
bars on the car seat adaptor on the attachment device in the correct
position (see picture 5) and gently push the adaptor until it clicks into
position. Check that the adaptor is securely attached by trying to fit it
from the chassis. Fit the car seat to the adaptor by locating the two
diagonal slots in the bottom of the car seat in the thin metal bar at the
front of the adaptor. Allow the back of the car seat to rest against the
back part of the adaptor. At the back of the car seat there is a hinged
clip. Fold the clip over the adaptor bar and clip and lock it into position.
Check that the car seat is securely fitted to the adaptor by trying to lift the
car seat from the chassis and adaptor.
See diagram facing page.
CONNECTING THE LINKED BRAKE BAR
Connect the linked brake to the rear wheel units by pushing the brake
levers into the corresponding hole on the rear wheel units. The brake
levers will lock into position. Push the brake levers down and engage
the parking brake to ensure it is working correctly.
FITTING THE FRONT WHEELS
Remove any packing & position the front wheel unit at the bottom of the
front leg of the pushchair. Push the wheel unit onto the pushchair leg
until it clicks into position. Check the wheel units are secure by trying to
pull them off.
OPERATING THE SWIVEL FRONT WHEELS
The front wheels can be used in swivel wheel or fixed wheel mode.
The operating lever is situated between the two wheels of each front
wheel unit. To switch between swivel or fixed wheel mode; push the
lever down for swivel wheel mode, pull the lever up for fixed wheel
mode.
FOLDING THE CHASSIS
The chassis can only be folded when the seat unit/pram body or car
seat have been removed.
Apply the pushchair parking brake and lock the front wheels. Pull both
finger catches and hold them in then push the handle grips downwards
until the frame starts to fold. Release the finger catches and grip the
closing handle at the back of the frame. Pull it upwards until the
pushchair is fully folded. Ensure the chassis is locked by pushing the
parallel tubes together.
ADJUSTING THE HANDLE HEIGHT
The handle height is adjustable to two positions. To adjust the handle
height, press in the button on the handle grip shaft, and slide up/down
the handle. The handle will click into one of the pre-set positions.
USING THE BRAKE
To engage the brake, press down the brake lever between each set of
rear wheels with your foot. Check that the brake is fully engaged on
both sets of wheels. To release the brake, with your foot lift up the
brake lever until the wheels move freely.
NEVER LEAVE THE PUSHCHAIR WITHOUT FIRST ENGAGING THE
BRAKE.
