PRIMARY FEATURES
4
CORRECT POSITION FOR CAR SEAT ADAPTOR
Picture 5
Back of chassis
Front of chassis
USING THE SAFETY HARNESS
Always apply the parking brake before placing your child in the vehicle.
The safety harness has two shoulder straps, two waist belts and a crotch
strap. Place the two shoulder straps over the child’s shoulders and the
waist belts around the child’s waist. The crotch strap should be placed
between the child’s legs. The waist belts & shoulder straps should be
clipped into the buckle at the end of the crotch strap. The harness can be
adjusted to suit your child by sliding the adjusters along the shoulder
straps and waist belts
.
To release the safety harness, push the buttons
on the centre buckle. D-rings for attaching a separate harness
conforming to BS 6684 can be found attached to the integral harness at
the base of the waist straps. ALWAYS USE THE HARNESS CROTCH
STRAP IN COMBINATION WITH THE WAIST BELT.
Picture 1
OPENING THE CHASSIS
Remove any packing and place out of the reach of children. Pull up on
both finger catches found just below the handle grips and lift the
pushchair by the handle grips, the frame will start to open. Push down
gently with your foot on the opening foot plate and tilt the handle grips
forwards.
ALWAYS USE THE SAFETY HARNESS
FITTING & REMOVING THE HOOD (SEAT UNIT & PRAM BODY)
FITTING THE REAR WHEELS
To attach or remove the hood; push the hood bracket into the plastic
housing until it locks into position. To remove the hood, depress the
plastic latch at the bottom of the bracket and pull upwards. NOTE: some
models are supplied (depending on style) with a valance that fits via a zip
to the rear bottom edge of the hood. The valance is designed for use with
the hood in conjunction with the seat unit.
Push each rear wheel unit onto each rear leg of the pushchair until it
clicks into position. The rear wheels will only click into position if the
brake mechanism is facing the rear of the pushchair. Check the wheel
units are secure by trying to pull them off.
9
