MAINTENANCE
Cleaning
- Never submerge the appliance in water, and don't fill it right up with water.
- Use a slightly damp cloth to clean the inside and outside.
De-scaling
Do not use any de-scaling products.
Depending on how hard the water used is and after a certain period of time, a layer of scale may build up in the tank. In
order for the sterilizer to work properly, the tank needs to be de-scaled regularly.
Proceed as follows: mix 100 ml hot water with 100 ml white vinegar and pour it all into the tank
(m)
. Leave to act for 30 minutes
then empty the appliance. Then use a damp cloth to clean it.
HOW TO USE
DRAINING RACK
- Place the tree assembly on the drip tray
(c)
.
- Wash your bottles carefully.
- Put the bottles and accessories on the branches of the tree assembly.
- The remaining water will flow on the white base and be collected by the drip tray.
STERILISER
1.
Remove the drip tray
(c)
under the appliance.
2.
Open the lid
(b)
.
3.
Take out the tree assembly thanks to its handle
(i)
and place it on the drip tray
(c)
.
4.
Fill the measuring cup
(l)
with fresh and clean water. Pour the water into the heater tank
(m)
.
5.
Place the tree assembly into the appliance. Place the bottles upside-down on the steam branches
(e)
so that the steam
can enter the bottles directly.
6.
Arrange the teats and rings onto the small double branches on the base of the appliances
(f)
. Put the caps on the little
branches at the top of the tree assembly
(g)
.
Please find on page 2 how to place the different kinds of bottles.
7.
Place the lid onto the appliance.
8.
Plug the appliance into the mains and press the “On” button
(j)
to start the sterilization process.
9.
The steam will go out through the steam branches
(e)
, the central trunk
(d)
and the bottom of the appliance, ensuring
a complete sterilisation.
10.
The lamp will illuminate to show that the appliance is working. It will go out automatically and an audible alarm will tell
you that the cycle is complete.
11.
Open the lid thanks to its handle
(a)
and remove the bottles carefully: they will be very hot.
12.
Always allow the appliance to cool between the cycles or prior to handle the bottles and accessories.
ADJUST THE STERILISER CONFIGURATION
You can adapt the configuration of the tree depending of the accessories you need to sterilise (see page 4). The central
trunk
(d)
and all the branches are removable so that you can get the white base
(h)
alone to sterilise big accessories such
as breast pumps.
To remove the branches, press them towards and pull them up.
TURBO STEAM ELECTRIC STERILISER
• Notice d’utilisation
10
COMPONENTS
a.
Lid’s handle
b.
Lid
c.
Drip tray
d.
Central trunk
e.
Steam branches
f.
Double branches for teats and rings
g.
Branches for caps
h.
White base
i.
Tree’s handle
j.
“On” button
k.
Steam hole
l.
Water cup
m.
Heater tank
• This appliance is not intended for use by persons (including
children) with impaired physical, mental, or sensory abilities,
or by persons lacking in experience or knowledge, unless the
person responsible for their safety has supervised and
instructed them in the use of this appliance.
• Waste Electrical and Electronic Equipment should be
disposed of by selective collection. Do not throw electrical
and electronic equipment away with un-sorted household
waste, but dispose of it at a selective collection point.
This marking indicates that this product should not
be disposed with other household wastes
throughout the EU.