![background image](http://html.mh-extra.com/html/babymoov/a002028/a002028_instructions-for-use-manual_464073009.webp)
IN CASE OF ANY LITTLE PROBLEMS
The bottle warmer doesn't heat up:
- check the "On" button to make sure it is properly switched on,
- check that the appliance is properly plugged in,
- check that there is not too much scale in the tank, and de-scale if necessary.
The warming cycles are too short or too long:
too much or too little water used. Adjust the quantity of water according to the temperature you want:
more water = hotter
less water = cooler
MAINTENANCE
Cleaning:
- Wait until the bottle warmer is cold before cleaning it.
- Always unplug the appliance before cleaning it.
- Never submerge the appliance in water, and don't fill it right up with water.
- Never use detergents to clean the appliance.
- Use a slightly damp cloth to clean the inside and outside.
- Adaptor ring, measure and baskets for jars can be washed in the dishwasher.
De-scaling:
Do not use any de-scaling products. Depending on the quality of water used and after a certain period of time, a layer of scale may
build up in the tank
(b)
. In order for the sterilizer to work properly, the tank needs to be de-scaled regularly.
Proceed as follows: Mix 100 ml hot water with 100 ml white vinegar and pour it all into the tank
(b)
. Leave to act for 30 minutes then
empty the appliance. Then use a damp cloth to clean it.
TULIPE HOME/CAR BOTTLE-WARMER •
Instructions for use
9
Amount of water
in the baby bottle
Amount of water to put
in the measuring device
for a baby bottle
prepared with
warm water
60 ml 4 ml
90 ml 5 ml
120 ml 5 ml
150 ml 5 ml
180 ml 5 ml
210 ml 5,5 ml
240 ml 5,5 ml
270 ml 6 ml
300 ml 6,5 ml
330 ml 6,5 ml
Jar
Amount of water
to put in the measuring
device for a jar
120 g 9 ml
200 g 12 ml
250 g 14 ml
Using the appliance in the car
Stop the vehicle and let the engine running.
8.
Put the bottle-warmer on a flat and steady surface inside your vehicle. Plug the cigarette-lighter adapter
(f)
into to the bottle-
warmer's power cable
(g)
.
9.
Plug the adapter
(f)
into the cigarette-lighter. Fill up the measuring device
(a)
with water by following the doses reported here
below and then pour the water into the warming tank
(b)
.
Repeat the steps above, from
3
to
7
.
7.
The bottle-warmer turns off automatically when the heating cycle is over. At the same time, the backlight ring
(h)
will turn green
for a minute, which means that the bottle is ready.
Take out the bottle or jar straight away with a pair of tongs or a cloth as they are hot.
To avoid the risk of burns, always check the temperature of the food before giving it to your baby. If you are using a baby bottle,
shake it well to mix the milk. Pour a drop onto the inside of your
wrist to check how warm it is. If you are using a jar, mix the contents and taste it to make sure it is not too hot.
Summary of Contents for A002028
Page 2: ...2 ...
Page 3: ...3 1 4 7 8 9 5 6 2 3 a f g b d c h e ...
Page 46: ...46 ...
Page 47: ...47 ...