22
HOW TO USE
23
HOW TO USE
Strap
Connector
B
ADJUSTING HARNESS STRAP HEIGHT & HEADREST: - STEPS IN CHANGING
SHOULDER STRAP SLOTS
A.
If installed in the vehicle, remove the restraint from vehicle as
instructed on page 27.
B.
At the rear of the restraint, remove both harness shoulder
straps from metal Strap Connector by slipping strap through
open slot.
C.
Pull the shoulder straps through slots
at the front of the restraint.
Insert finger above the webbing
to ensure shoulder slots in
headrest and restraint match up.
Harness shoulder straps.
C
E
Fig.1.
E.
Thread the shoulder straps through the slots (E).
Engage the straps to the metal strap connector (see B).
The harness straps must always be routed straight through the
headrest and shell slots (3) and (4).
D.
Release the headrest at the back of the
restraint by rotating the lever down to
loosen headrest clamp (1). Slide the
headrest up or down to suit the height
of your child. Ensure that the headrest
slots align with the corresponding slots
of the restraint body. Insert a finger to
check alignment. (See illustration Fig.1.).
Rotate the clamp upward to lock the
headrest clamp (2). DO NOT lock the
headrest in any other position, otherwise
the slots will not align correctly.
Align Slots
D
(2) Lock
D
(1) Release
Headrest Clamp
Never adjust the height of the headrest without changing the harness strap slots.
Never route the harness through offset slots (5).
3
4
5
