11
Rearward Facing - For Baby Use
L
Pull sash portion of seat belt until all slack is removed from Lap portion of seatbelt. Adjust seat belt to hold
the restraint firmly against the vehicle seat back. Allow excess belt to feed back into retractor.
Note: Seat belt buckle and tongue must not rest between restraint cover and restraint. If the seat belt
buckle is adjustable, adjust the buckle as low as possible away from the restraint.
Ensure Upper Anchorage Strap is tightened, attached to the Anchor Fitting
and that straps are the same length on both sides of Attachment Clip.
Front of vehicle
Do not use this slot for
baby use installation
Feed seat belt between
restraint cover and
restraint body.
Pull sash
portion of seat
belt to remove
slack.
A single twist is
required for easy
access to the Upper
Anchorage Adjuster.
HOW TO INSTALL
HOW TO INSTALL
M
Attachment
Clip
Extension
Strap
Attachment Clip must
not be in front of the
vehicle seat front.
Attachment Clip must
be behind the front of
the vehicle seat.
Important: If using an Extension Strap, positioning the
Attachment Clip above the baby may lead to injury in
an accident therefore make sure that the Attachment
Clip is not positioned in front of the vehicle seat.
Tighten adjustable upper anchorage strap by pulling
adjustment strap to remove slack, but do not over-
tighten causing the restraint base to lift off the
vehicle seat.
K
Hook the attachment clip to the anchor fitting. Remove as
many twists as possible from the upper anchorage strap.
THIS TETHER STRAP MUST ALWAYS BE FITTED WHEN
THE CHILD RESTRAINT IS USED IN A VEHICLE.
Pull Upper Anchorage Strap (A) to tighten.
Storage
Strap
Pull Adjustment Strap
to remove slack
Storage
Strap
A
B
Fully press Adjuster
Button (A)while pulling Upper
AnchorageStrap (B) to lengthen.
J
Anchor fitting
Attachment
Clip
A
Up to 8kg
Up to 8kg
Up to 12kg
