Digital Video Baby Monitor
EN
14
A selection of 8 lullabies (Lullaby 1–8) and the option "Play All" (play all lullabies) will appear in
the middle of the screen. Use the buttons C
7
and C
8
to select a sequence number of a lullaby
or the option to play all lullabies. Confi rm the selection by pressing the button Menu/OK C
5
.
The options "Play Once" (play once), "Play Repeat" (play repeatedly) and "Stop" (stop playback)
will appear on the screen. Select one of these options and confi rm it by pressing the button
Menu/OK C
5
. After a short while, the screen C
3
will automatically switch to the mode for
displaying the video registered by the camera B
3
. While the lullaby is being played, the symbol
and the sequence number of the lullaby that is being played will appear in the top bar of the
screen C
3
. To immediately stop playback of the lullaby, select the option "Stop" (stop playback).
■
Setting the VOX function
–
The VOX function enables a voice-activated transmission mode to be set. In this mode, the
baby monitor will always start transmitting the picture when it detects any voice or noise. When
no sound is being transmitted, the baby monitor will automatically switch to the ECO mode and
the screen C
3
will turn off. This reduces the transmission power to ensure power effi cient
operation and minimisation of radiation.
–
There are 3 sensitivity levels that can may be set or the VOX function may be deactivated. To
set the sensitivity or to turn off the VOX mode, proceed as follows. Press the button Menu/OK
C
5
. The main Menu panel will appear in the bottom part of the screen C
3
. Use buttons C
qg
and C
qh
to scroll through the main Menu items. Select the item "Voice Sensor" (voice sensor).
–
The items "Low" (low sensitivity), "Medium" (medium sensitivity), "High" (high sensitivity) and
"Off" (deactivate the VOX function) will appear in the middle of the screen. To select an item,
use buttons C
7
and C
8
and then confi rm the selection by pressing button Menu/OK C
5
.
–
When the baby monitor is switched to ECO mode, the screen C
3
is turned off. Nevertheless,
you may turn on the screen C
3
for a certain time by pressing any control button on the front
panel of the parent unit A
1
. The message "ECO mode activated“ (ECO mode activated) will
appear on the screen C
3
. In the top bar, it will be indicated that the baby monitor has no signal.
The signal will be restored once the baby monitor starts sending and transmitting the picture.
■
Setting air temperature units, the warning signal and the alarm signalling that the minimum or
maximum set temperature is exceeded
–
The baby unit A
2
continuously monitors the air temperature in the room in which it is located.
In the section "Temperature" (temperature) in the main Menu, you may select the unit in which
the air temperature will be shown on screen C
3
. In this section, you may also set the warning
signal and alarm function, that is triggered when the minimum and maximum temperature that
you set is exceeded.