BBS05-IM-120423
Never immerse the base unit into water.
Before plugging the sterilizer again to the mains, make sure the base unit is thoroughly dry.
After each use, pour away any remaining water from the sterilizer base.
Using filtered water with your sterilizer can reduce lime scale build up. You should de-scale your sterilizer every 4 weeks to ensure it work
efficiently otherwise may it affect the operation of the sterilizer.
To de-scale your sterilizer, mix one sachet of citric acid (10gms) with 200ml of water. Pour the mixture into the sterilizer base, do not put
anything sterilizer part on the base and switch it on for around 1 minute and then switch off and leave it with the warm mixture for 30 minutes.
Drain and rinse out sterilizer. Run a full cycle with only the sterilizer lid on with 200 ml water. Wipe out the sterilizer being emptied and it is now
ready for use again.
If the cord is damaged it must, for safety reasons, be replaced by an Authorized Service Center.
If the sterilizer fails to operate, unplug the unit for 15 minutes, plug in and try again. If problems persist, check the trouble shooting section. If
problem still persist after checking with the trouble shooting section, then contact Authorized Service Center.
Sterilizer not working
at all
Check that the sterilizer is plugged to the main supply. Check
fuse in the plug if there is any.
Bottle with marks after
sterilizing
Sterilizer needs de-scaling. Refer to the “ DE-SCALE YOUR
STERILIZER” section
“ ” icon on display
panel flash between
red and green
continuously
Not enough water or not water is placed in sterilizer. Switch
off, remove water, replace with 150ml of water and restart the
cycle;
Or too much scale is built up on the stainless steel surface of
the heating element. De-scale must carried out immediately.
Details refer to “DE-SCALE YOUR STERILIZER” section.
“ ” icon continuously
flashed between red
and green and the
start/stop button
cannot reset the
sterilizer.
The internal dry boil protecting device is not reset yet. In this
case, don’t use the item in the sterilizer and the sterilizing
cycle “MUST” restart completely. You need to remove any
remaining water and replace with new water before starting
the new cycle. If the sterilizer still not able to restart, then
unplug the unit, wait for 15 minutes, plug in and retry.
SAVE THESE INSTRUCTIONS
Correct Disposal of this product
This marking indicates that this product should not be disposed with
other household wastes throughout the EU. To prevent possible harm
to the environment or human health from uncontrolled waste
disposal, recycle it responsibly to promote the sustainable reuse of
material resources. To return your used device, please use the return
and collection systems or contact the retailer where the product was
purchased. They can take this product for environmental safe
recycling.
Tai Yu International Mfy. Ltd.
South Seas Center, Tower II, 8/F1., Unit 804 & 805A, 75 Mody Road, TST East, Kowloon, Hong Kong.
Electronic Steam Sterilizer
BBS05
Voltage: 220-240V ~ 50-60Hz
Wattage:
1180-1400W
Capacity: 6 sets of baby bottles
TROUBLE SHOOTING
INSTRUCTIONAL MANUAL
DE-SCALE YOUR STERILIZER
SERVICE AND CUSTOMER CARE
