12
13
9. Secure 2 of the frame clamps (Part Z) using a screw (Part #1211) to the
platform blocks (Part Y) on the sleeping platform (Part D) using the Allen
wrench as shown.
Do not overtighten.
Next stand the babybay right side up and secure the other 2 frame clamps
on the back of the babybay using the same method. Screws should be finger
tight.
Do not overtighten. (Sleeping platform height will need adjusting later).
#1211
#1211
10. Insert the safety barrier (Part F) into the top of the sleeping platform by
placing the wood peg into the hole. Firmly secure the safety barrier by
inserting and tightening 2 screws (Part #1211) from the bottom of the
sleeping platform using the Allen wrench as shown. Screws should be hand
tight.
Do not overtighten.
#1211
F
ATTACHING YOUR BABYBAY TO YOUR BED
NOTE: The sleeping platform height must be at least 10 inches below the top
rail.
≥ 10 INCHES
NOTE: Always use the appropriate attachment system when using in bedside
sleeper mode.
Fixing Set: Attaching to Top of bed frame
NOTE: The safety barrier must be below the top of parent’s mattress.
1. Use the Allen wrench to remove the screw on the side of each fixing set,
position the metal arms facing down. Reattach the clamps to the fixing sets
on the babybay as shown, making sure to leave the screws a little loose.