TO ENSURE SAFE OPERATION OF YOUR STROLLER,
PLEASE FOLLOW THESE INSTRUCTIONS CAREFULLY.
RETAIN
THESE
INSTRUCTIONS
FOR
FUTURE
REFERENCE.
ASSEMBLY:
*
Remove stroller from box. The front wheel, rear wheels, footrest, child
tray and parent tray need to be installed prior to use.
*
To attach the front wheel, unfold stroller as described in the section
following. See figure 1.
* Lean the stroller backwards so that it rests on the handle and rear axle
frame and the front wheel forks are pointing upward.
* The front wheel features a quick release attachment system. See figure
3. Slide the front wheel onto the front forks. See figure 2. The quick
release must be loose enough for the wheel to slide on and the wheel
lever must be in the open position (see figure 6). Line up the tab on the
Holding Plate with the slot on the fork plate. With the wheel in position,
tighten the finger nut on the axle until it is very close to contacting the
fork. See figure 4. Rotate the lever to the closed position as shown in
figure 5. You should feel significant resistance when closing the lever
and the wheel should be held tightly. If you do not, open the lever and
tighten the finger nut a bit more and close the lever again. Continue to
do this until the wheel is held tightly in the fork.
* The front swivel wheel can be locked by pushing the switch. See Figure
7a. To release the swivel wheel, pull back the lock mechanism.
See Figure 7b.
Fig 2.
Parent Tray
Base
Footrest Screws
Rear Wheels
Front Wheel
Car Seat
Stroller
Fig 1.
Child Tray
Footrest
Fig. 6
Fig. 5
Open
Washer
Ring
Fig. 7b
Fig. 7a
