33
34
Copyright © 2020, Baby Trend, Inc.
Copyright © 2020, Baby Trend, Inc.
3. Locate rear facing belt path openings
(Fig. 33a).
4. Remove both cup holders by pressing
the retention tab and set to the side
(Fig. 33b).
5. Pull the seat fabric back and route
LATCH Lower Anchor J-Hook connector
through the rear facing belt paths.
NOTE:
Remove any twist in webbing to
ensure the webbing lies flat for securing
the car seat to the vehicle
(Fig. 33c).
6.
Attach the lower J-hook connector to the
vehicle anchor used for LATCH. Place
your hand in the seat and push down
while pulling on the free end of
Lower
Anchor J-Hook
to tighten (Fig. 33d).
Fig. 33a
Fig. 33b
Fig. 33c
Fig. 33d
1 2
3
4
1 2
3
4
5
7. Pull up on each Lower Anchor J-Hook
connector to ensure the lower anchor
j-hook is securely fastened.
8. Reinstall the cup holders. Please note LH
or RH on bottom of cupholder. LH or RH
refers to child’s right and left (Fig. 34a).
9. Pull seat fabric back over each cup holder
(Fig. 34b), and then front of seat to secure
(Fig. 34c).
1 2
3
4
5
1 2
3
4
5
Fig.34a
Fig. 34b
Fig.34c
5.0 Installation and Use
Internal Harness Mode
5.0
Installation and Use
Internal Harness Mode