1. Have child sit on the jump seat facing backwards. Secure the seat belt,
which is attached to the back of the seat, around the childʼs waist, and
buckle to the crotch strap. See fi gure 11.
2. Adjust the seat belt to be snug around the childʼs waist.
3. To release, apply pressure to both sides of the male clip until the clip
is released. This process requires a moderate amount of effort so as to
prevent an accidental release by your child.
4. Be sure that the childʼs feet are fully on the platform at all times.
TO ADAPT THE STROLLER TO CARRY
INFANT CAR SEATS
1. Please see Car Seat Chart following to determine the proper confi guration
of the Snap N Go for your Infant Car Seat. See the page following that
corresponds with your brand of infant car seat for use with your car
seat.
SEATBACK POSITIONING
1. The front seat has a two position recline. To recline the seat, rotate the
recline bar and press backward on the seat back. Please see fi gure 12. To
place the seat in the upright position, press upward on the seat back while
rotating the recline bar.
2. The upright position should be used only for a child that is at least 6
months old. Note: Seat does not fully recline.
5
Fig. 11.
Fig. 12.
TO USE JUMP SEAT
