Upper Looper
1. With the presser foot up and machine lock button in the locked position (See fig. A-B, page 15),
set the looper threader selector lever to "U" for upper looper threading. (See fig. B, page 15)
2. Place the thread cone or spool on the second spool pin from the front on the right side of the
thread stand. (fig. C) Slip the thread into the telescopic antenna thread guide "A" directly above
the spool, snap into the thread guide "B" at the top of the front of the machine, then through the
slot on the front cover. (See fig. C, below)
3. Pull 18 inches (45cm) of thread through guide "C". Insert the end of the thread into the threading
port "U", about 1 inch (2.5cm). Use tweezers, if necessary, to insert the thread end more easily.
(See fig. D below)
4. Depress the looper threader lever. (fig. D below) If the thread does not go through the upper
looper eye with one push, depress the looper threader lever again until it does, and leave thread
hanging loose.
5. Move the lock button release lever to the right, to unlock the machine.
*Be sure at least 1" of thread is inserted into the threading port.
U
L
U
L
C
C
D
D
Looper Threader Lever
Looper Threader Lever
B
A
A
22
B
B
C
C
33
11
2
16
T
H
R
E
A
D
I
N
G
