8
Photo 5 (View of Front Handles)
Photo 4
Installing Front Handles
CAUTION:
Unplug the Baby Lock Jewel from
the electrical outlet. All power to the machine
must be turned off when installing the front
handles. Failure to do so can result in
damage to the machine.
IMPORTANT NOTE:
Care must be taken to
not pinch the ribbon cable under the handle
when it is tightened to the machine.
Locate the two longest bolts and the appropriate
Hex wrench. To install the handles, tilt the screen
forward. Line up the two holes on top of the
handles with the pre-drilled holes on top of the
machine. Slide a washer onto the bolt, then slide
a bolt into each hole until it stops. Hand tighten,
and then use the Hex wrench to securely fasten
the handles to the machine (
Photo 4
).
Once both bolts are in place, plug the ribbon
connector into the serial port on the back casing
of the machine (
Back-Side Diagram B, #19 on
page 6
). Make sure the pins are lined up so they
are not damaged when the plug is pushed in.
Push the plug securely in place.
