Baby Lock embellisher EMB12, Instruction And Reference Manual

Page: 12 / 16

1. Rotate the yarn & ribbon guide toward the back
of the machine. Align the guide with the top of
the yarn stand pin.
2. Place ribbon on the yarn stand.
3. Insert the ribbon into the slot of the yarn &
ribbon guide.
4. Rotate the ribbon guide toward the front of the
machine.
5. Insert the ribbon into slot of the ribbon
guide.
6. Rotate the handwheel to bring the needle bar to
its highest position.
7. Slide ribbon into the ribbon slot of the cloth
presser.
8. Raise the cloth presser lifter lever.
9. Place fabric under the cloth presser.
10. Lower the cloth presser lifter lever.
ATTENTION: Only guide the fabric towards the
back of the machine while embellishing with ribbon
or using the ribbon slot on the cloth presser to
avoid the ribbon from getting tangled.
NOTE: Maximum width of the ribbon slot is 10mm
therefore ribbon over 10mm is not recommended
for this machine.
If ribbon is narrower than 10mm the needles will
embellish on outside of ribbon area.
Since there is such a wide variety of ribbons to
select from use care when using dense or thick
ribbons. It is recommended to test sew a sample
using all ribbons before sewing on your project.
Turn handwheel several times to insure there is no
resistance with needle penetration.
6. Ribbon Embellishing
9