Baby Lock embellisher EMB12, Instruction And Reference Manual

Page: 9 / 16

4. Start Embellishing cont.
Layer the cloth/fabric/materials that will be felted
together to create the embellishment. Make sure
the smaller piece to be felted is on the correct side
of the project.
NOTE: Depending on the look you want to achieve
this can be either right or wrong side of project.
Place the layers to be felted together under the
cloth presser. Lower the cloth presser lifter lever.
If needed, adjust the height of the cloth presser at
this time so the project can move freely under the
cloth presser.
Move the cloth/fabric/materials in any direction so
that the needles can mesh the layers together.
ATTENTION: Always check to make sure the fab-
ric under cloth presser will move freely or does not
flap before embellishing. If necessary, adjust the
cloth presser height adjusting screw.
When you have finished embellishing, turn the
handwheel toward you making sure the needles
are completely out of the project. Never remove
the embellished project with the needles in the
project, as the needles can bend or break.
NOTE: Always make sure the cloth presser lifter
lever is lowered before starting to embellish. If the
cloth presser lifter lever is not lowered, the
materials can easily be lifted by the needles and
can cause needle breakage.
Remove the sewing table by sliding it to the left
and the machine will convert to a free arm. This
will allow you to embellish sleeves, pant legs, and
small areas.
This will also give you access to the free arm door
to clean out the lint that has accumulated from
embellishing.
6