![background image](http://html1.mh-extra.com/html/baby-lock/ellure-blr/ellure-blr_instruction-and-reference-manual_3327862075.webp)
Selecting Stitching
73
3
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Saving stitch settings
This machine is preset with the default settings for the
stitch width (zigzag width), stitch length, thread
tension, programmed thread cutting, and automatic
reverse/reinforcement stitching for each stitch.
However, if you wish to save specific settings for a
stitch so that they can be used later, press
after
changing the settings to save the new settings with
the selected stitch.
This feature can be used only with utility stitches.
To use a stitch length of 2.0 mm for the
straight stitch
a
Select a straight stitch.
b
Press
.
Memo
z
The default stitch length is 2.5 mm.
c
Set the stitch length to 2.0 mm.
d
Press .
• To reset the selected stitch pattern to its
default settings, press
, and then press
.
X
The confirmation message is displayed.
e
Press .
Note
z
The next time that the same straight stitch is
selected, the stitch length is set to 2.0 mm.
z
All stitch settings (stitch width (zigzag
width), stitch length, thread tension,
programmed thread cutting, and automatic
reverse/reinforcement stitching, etc.) are
saved, not just the setting that was changed.
When the same stitch pattern is selected, the
last settings saved are displayed even if the
machine was turned off. If the settings are
changed again and
is pressed, or if
is pressed to reset the setting to its
default, the new settings are not saved unless
is pressed another time.
Even if
is pressed, the settings for
programmed thread cutting and automatic
reverse/reinforcement stitching cannot be
reset.
Summary of Contents for Ellure (BLR)
