![background image](http://html1.mh-extra.com/html/baby-lock/crown-jevel-blcj18/crown-jevel-blcj18_instruction-and-reference-manual_3286839013.webp)
10
Figure 5 (View of Front Handles)
Figure 4
Installing Front Handles
CAUTION:
Unplug the Baby Lock Crown
Jewel from the electrical outlet. All power to
the machine must be turned off when install-
ing the front handles. Failure to do so can
result in damage to the machine.
IMPORTANT NOTE:
Care must be taken to
not pinch the ribbon cable under the handle
when it is tightened to the machine.
Locate the three longest Allen screws and the
5.0mm Allen wrench. To install the handles, tilt the
screen forward. Line up the three holes on top of
the handles with the pre-drilled holes on top of the
machine. Slide a star washer onto the Allen screw,
then slide a bolt into each hole until it stops. Hand
tighten, and then use the 5.0mm Allen wrench to
securely fasten the handles to the machine (
Figure
4
).
Once the Allen screws are in place, plug the ribbon
connector into the serial port on the left-hand side
of the machine (
Back-Side Diagram B, #19 on
page 7
). Make sure the pins are lined up so they
are not damaged when the plug is pushed in.
Push the plug securely in place.