![background image](http://html1.mh-extra.com/html/baby-lock/blmy/blmy_service-manual_3412732183.webp)
4 - 22
Adjustment (Main Unit)
Side feed line adjustment
1. Start test mode (refer to 4.4 "Test Mode" for test mode startup methods).
2. After pressing
and selecting
, press
, and after selecting "FORWARD AND REVERSE FEED,"
press
again until the needle moves to the left (base line) position and select "Feed line adjustment mode."
3. Set up two pieces of broadcloth, one on top of the other, on the sewing machine, press
to operate in "Side
feed line adjustment mode" and check the shape of the horseshoe pattern.
*Key point
• The horseshoe pattern should be oriented almost perfectly to the side
• The length of the upper side of the horseshoe pattern should be 26-31 mm.
4. When the feed dog lateral position is center, adjust the set screw collar in the feed module so that the vertical
adjusting screw is almost perfectly vertical when viewed from the rear of the sewing machine.
5. Adjust the up and down gap on the right side of the horseshoe to 4 - 6 mm using
or
.
6. Adjust the difference in length between the top and the bottom to less than 1 mm using
or
.
6
Material drift correction value
Left and right length correction value
Fig.A
Fig.B
Vertical
The bottom
Fig.C
Positive correction
Negative correction
Fig.D
Less than 1mm
Negative correction
Positive correction
Summary of Contents for BLMY
