Needle Threading Mode
RevolutionAir Needle Threading Guide
A c c laim h as 3 t ypes of t h read ing M od es .
MODE 1:
Press the “Push to thread needles button” once, threading
pum p w ill w ork . P res s t h e b ut t on ag ain, t h read ing pum p
w ill s t op.
MODE 2:
Press the “Push to thread needles button” once, threading
pum p w ill w ork 3 s ec ond s and t h en s t ops .
MODE 3:
Press the “Push to thread needles button”, threading
pum p w ill operat e w h ile k eeping b ut t on pres s ed .
Note: Your Acclaim is set to MODE 1 at the factory.
How to change the Threading Mode
1 . C onnec t ing t h e pow er s upply.
2. Power switch is in the OFF position.
3. Press and hold the “ Push to thread needles button”, turn power switch ON while holding button for
ov er 3 s ec ond s .
4. Threading Mode changes “Mode 1” → ”Mode 2” → ”Mode 3” → ”Mode 1” ········.
This guide is designed to aid if having difficulties with needle eye thread
plac em ent w h en us ing t h e R ev olut ionA ir N eed le T h read er.
How to use RevolutionAir Needle Threading Guide
1. Set up the Acclaim for needle threading. (see page 20, 1 to 6)
2 . C lip t h e upper s ec t ion of t h e R ev olut ionA ir N eed le T h read ing
Guide onto the needle bar and the guide’s lower section against the
needle clamp. (fig. A)
3. Make sure RevolutionAir Needle Threading Guide is completely set
up just in front of the needles. (fig. B)
4 . P lac e t h e end of t h read d irec t ly in f ront of t h e d es ired need le eye po-
sition. (fig. C)
5. Press the “Push to thread needles button”. (see page 20, 7 to 9)
6. Remove RevolutionAir Needle Threading Guide. (fig. D)
7. Set the threading lever to serging position.
8 . C los e t h e b lad e c ov er and t h e f ront c ov er.
Note:
T h e elas t ic applic at or f oot c annot b e at t ac h ed w h en us ing t h e
“RevolutionAir Needle Threading Guide”
L
R
A
B
C
D
P us h t o
t h read need les
b ut t on
P ow er s w it c h
2 1
T
H
R
E
A
D
I
N
G
