Baby Jogger city suite, Assembly Instructions Manual

Page: 11 / 24

11
PLAYARD SET UP
1 Unzip playard bag .
2 Remove mattress and playard from
bag.
3 Place folded playard on the ground.
4 Unfold playard so that the opening
of the playard is facing up.
5 With one side resting on the ground,
pull the legs out from the other side
until they lock into place.
6 Repeat on the other side.
CHECK: Once playard is fully upright,
make sure that all legs are completely
locked into position.
7 Insert mattress into playard.
CHECK: Ensure that mattress cover is
completely zipped.
8 Mattress should be flat on the floor
of the playard.
9 Pull the snaps connected to the
bottom corners of the mattress
through the openings on the playard
floor.
10 Secure all four snaps to the floor of
the playard.
11 Playard frame is fully assembled.
WARNING - Make sure top rails and
all legs are locked before using.
BASSINET SET UP
12 Unsnap and remove mattress from
floor of playard.
13 Locate zipper underneath flap.
14 Unzip bassinet storage zipper
following around the entire top rail
of playard.
15 Bassinet fabric and support tubes
should all be accessible now.
16 Locate the bassinet center zipper
and zip completely.
WARNING - Ensure that bassinet
center zipper is fully zipped with no
red visible.
17 With the bassinet fabric fully zipped,
locate the bassinet support tubes.
18 Connect both sets of tubes.
CHECK : Bassinet support tubes MUST
be assembled before placing mattress
in bassinet. Ensure that mattress cover is
completely zipped.
19 Fold mattress as shown to insert into
bassinet. Tuck the outer panels of
mattress into the mattress side panel
covers on either side of the bassinet.
20 Push center of mattress down
so that the two center panels of
mattress are flat against the bottom
of the bassinet.
CHECK: If you can see the warning label
on the bassinet, the mattress IS NOT
installed correctly.
21 Bassinet is fully assembled.
BASSINET DISASSEMBLY AND
STORAGE
22 To begin bassinet disassembly, lift
up on both sides of the center of
the mattress to remove.
23 Disconnect each set of bassinet
support tubes.
24 Unzip bassinet fabric.
25 Locate bassinet storage zipper
inside the top rail and connect.
26 Completely zip up the bassinet
fabric and tubes.
27 Close the zipper flap to cover the
zipper.
28 Bassinet is completely stored.
PLAYARD STORAGE
NOTE: If mattress is in playard, remove
before attempting to store.
29 Start fold by pressing leg fold
buttons on one side.
30 Press buttons on other side to
complete leg fold.
31 Locate top rail fold buttons.
32 Press both buttons to fold frame in
half.
33 Playard is completely folded.
34 Place folded frame into carry bag as
shown. Folded mattress should nest
into frame to allow bag to be zipped.
35 Zip bag and playard is fully stored.
EN