Operation
1. Place the sensor pad on the bed bottom. Place the mattress on the sensor pad and be sure
that the sensor is well positioned with the mattress using the following guidelines:
•
Center of the sensor pad should be approximately in the position of where the baby’s
chest will be.
•
The pad should be on a smooth & solid surface – It should not be bent!
•
If there is only a spring grid supporting the bed, place a solid board (wood, plywood
etc.) between the pad and the spring grid.
•
If you want to use the BABY CONTROL in multiple beds, use the extra sensor pads.
•
Install them in each bed and change only the location of the control unit.
•
Up to two sensor pads can be used in each bed with a single control unit if the child has
grown up.
2. Connecting batteries to the control unit
•
Remove the upper section of the unit
•
Use only 2 new size AA alkaline batteries.
•
Polarity of the batteries is clearly marked in the battery compartment.
•
If the batteries are OK the indicators will flash and you will hear a beep.
•
Switch the unit OFF again (position 0).
•
If there is no beep after turning ON, check the batteries.
3. Attaching the control unit to the bed – using the fastening belt:
•
The unit should be visible and should not be covered by anything.
•
For bigger children we recommend to locate the unit out of their reach.
•
It is also possible to use a wall mount holder to attach the control unit to the wall.
4. Connecting the sensor’s cable to the unit – you should hear a click:
•
Route the cable in such a way that there is no slack long enough to make a loop. For
bigger children the cable should be out of their reach.
•
If you do not use the entire length of the cable, fix the excess firmly under the mattress.
•
If you position the control unit in another room, use the extension cable (5 m), which is
provided with the set, only one extension cable can be used.
•
If you use two sensor pads in a bed, a cable splitter is provided in the set.
•
To disconnect the cable from the unit – press the connector tab towards the cable.
Usage
1. Put the baby to bed.
2. Turn on the unit (confirmed by a beep (3) and a flash (6,7) of all LED indicators).
•
Press and hold the red button (1) for 2 seconds.(if the time is less then 2 seconds the unit
will not be switched on!)
•
The sensitivity level (2) shows up 10 times after the turn on, and then the digital display
will be blank.
