30
Re
v08
5. INSTALLING THE CHILD SEAT FORWARD FACING
GROUP 1
(TOP TETHER)
GROUP 1 only. From 9 months to 4 years
approx. (9-18 kg)
NOTICE
WARNING! once the car seat is installed, if another recline position
is selected, you should check the tension of the Top Tether system.
1. Before installing the child seat, select 1, 2, 3 or 4 recline positions
(fig. 5.1). Pull the lever
(I)
forward and adjust the angle of recline
without releasing the lever until the seat is in the desired position.
4. INSTALLING THE CHILD SEAT REARWARD FACING
GROUP 0+
(3 POINTS BELT ONLY)
GROUP 0+ only. From birth to 12 months
approx. (0-13 kg)
NOTICE
1. Before installing the child seat, the position of the seat must be
adjust to rearward facing. To do it, pull and keep up the lock system
of the seat base
(S)
(fig.3.1). Rotate the seat to rearward facing (fig.3.2).
2. Place the child safety seat in the back seat of the vehicle facing in
the opposite direction of travel ensuring it is resting firmly against
the backrest.
3. Unlock the harness to help seat installation.
4. Take out the reducer cushion
(K)
from the seat.
5. Pass the abdominal strap of the seat belt through the lower seat
guides
(J)
(fig. 4.1) and buckle the vehicle seat belt until you hear a
click (fig.4.2).
6. Pass the diagonal section of the seat belt through the
corresponding upper guide
(L)
.
7. Take the remaining slack of the diagonal section of the 3-point
seat belt. And make sure it is as tight fitting as possible.
8. Ensure the straps are not twisted or knotted at any point.
9. Place back the reductor cushion
(K)
on the seat.
CAUTION! Remove the reducing pad
(K)
from 8 kg and above.
