Documentation KNXEASY
10
b.a.b-technologie gmbh
KNXEASY version. 1
2.3
INSTALLATION
When mounting the device and during the initial operation please take care and note the following
information to prevent any risk.
Attention!
Device may be destroyed in case of wrong use. Operations under voltage may cause residual
voltage. Before connecting the device please disconnect the installation environment from voltage.
Please pay attention, that
KNXEASY
is protected against polarity reversal, but not against surge
voltage. In case excessive voltage will be connected,
KNXEASY
can be destroyed.
GENERAL
Environment
Voltage:
12 - 30 Volt DC
Power consumption:
<= 5 W
Climate persistent:
acc to EN 50090-2-2
Ambient temperature:
0 - 45°C
Rel. humidity (not condensing):
5% - 80%
Plugging the device
Snap the device onto the top-hat rail acc to 60715
Power supply
Please care for sufficient performance when selecting the power supply. KNXEASY needs 300mA at 12 Volt
DC during the boot phase!
Connect the power supply according to the marking with the spring clips
For power supply, the non-choked output of an EIB-power supply can be used, if available. (Please consider
of adequate power reserves).
To supply the KNXEASY Power Over Ethernet (POE) can be used. Plug in the network cable (LAN) into the RJ
45- connector
.
Ethernet
For programming the KNXEASY it is necessary to access via LAN. This can be done both using an existing
LAN network or via direct connection. Plug in the network cable (LAN) into the RJ 45- connector
.
Prerequisites of the Client PC
If you need to configure KNXEASY
with the web interface, a PC with network adapter and an up-to-date
browser is necessary.
ETS
KNXEASY does not require ETS application. However for the best use of KNXEASY, KNX group address
information are necessary. To import them into KNXEASY the ETS version 4 is needed.
The device warms up during operation. Take care about the maximum ambient temperature and for
sufficient thermal discharge. An error message will be displayed on the LCD display if the maximum
temperature (90°C) is reached. You can check the temperature on the LCD menu (see ”
”) or
in the web interface (see “
”).
