01 – Lid
02 – Juice Chamber
03 – Sieve
04 – Cup
05 – Small Crown
06 – Large Crown
07 – Housing
08 – Base
09 – ON/OFF Switch
10 – Voltage Selector Switch
.
Picture - 01
1. Introduction
1.1 Safety
The Juice Extractor model ESB-SUPER is simple to use and easy to clean. For your safety,
read the following instructions to avoid accidents:
1.1.1 -Unplug the machine for cleaning, maintenance or any other service.
1.1.2 - Never make use of any tool or instrument that is not originally part of the machine
during any operation.
1.1.3 - Before switching the machine on check if Crown Nº 05 or 06 (Pic. 01) and the
Juice Chamber Nº02 (Pic-01) are firmly attached to their right positions.
1.1.4 - Never spray water directly to the machine.
1.1.5 - Never use wide cuffed clothing during operation.
1.1.6 - Do not operate the machine wearing wet clothes or wet shoes.
1.1.7 - Before operating the machine be sure it is grounded properly.
IMPORTANT
This equipment must not be used by children or any persons with reduced physical or
mental aptness, lack of experience or knowledge, unless they are under supervision or have
received from the person responsible for safety, proper instructions on how to use the
equipment.
IMPORTANT
If the Power Cord is not in good usage conditions, it must be replaced by
qualified personnel.
1.2 Main Components
All components of this machine were designed and manufactured using carefully selected
materials to their proper functions, according to test standards and experience of Siemsen.
02
01
02
03
04
07
09
10
05
06
08
09
5Analysis and Problems Solving
5.1 Problem, causes and solutions
The Juice Extractor model ESB-SUPER was designed to operate
with the need of minimum maintenance but the natural wearing caused by
longer use of the equipment may occasionally cause some malfunctions.
If such problem occurs with your Juice Extractor, refer to Table 02 in which
the most common situations are listed with recommended solutions.
Table - 02
*
.
Lack of Electric Power
*
The machine does not switch
on.
Problems
Causes
Solutions
*
.
Problems in the electrical
circuit
*
.
Check if plug is connected
to its socket, or if there is
electric shortage
*
.
The crown turns but when in
contact with the product, it
stops
*
.
Crown groove worn out or
broken
*
Call technical assistance.
*
.
Change the crown
5.2
Electrical Diagram
On/Off Switch
Motor
Voltage Selector Switch (110v / 220v)
*
.
Damaged electric cable
*
.
Failure during transport of
product
*
Call technical assistance.
