8
4.1.3 Advices
Be sure this Manual INSTRUCTION has been fully understood . Each function or
operation procedure has to be perfectly clear .
Any manual command ( button , pulses , electric switch , lever, etc ) shall be given
only after to be sure the correct command is given .
If an electric supply failure happens , the machine shall immediately be switched
OFF .
Avoid any strikes on the machine , since they could produce failures or a bad
performance .
Avoid water, dust or dirt to get inside the electrical or mechanical components of
the machine .
DO NOT CHANGE the machine original characteristics .
DO NOT TEAR, WITHDRAW OR GET DIRTY , ANY SAFETY OR IDENTIFICATION
LABEL . If a Label is lost or unreadable ask for a new one to your Dealer .
4.2 Cares to be taken before to starting the Juicer
IMPORTANT
Read carefully this INSTRUCTION before to starting the machine . Be sure they
have been correctly understood . Any doubt contact the department Chief or the
Dealer .
4.2.1 Danger
Electric wires must have a perfect insulation, any damage may cause an electric
shock .
Before to using them be sure they are in good conditions .
4.2.2 Cares
The electric cord , used to feed electricity to the machine has to have the right
section to be able to support the machine motor power rating . Any electric wiring
running over the floor near the machine shall be fully protected to avoid short
circuits .
4. General Warnings
The General Warnings were prepared to properly instruct the operators and the
maintenance team .
The machine shall only be given to the operators in good working conditions and they
shall be properly oriented about how to use it safely , by the Dealer .
The operator shall only use the machine after a complete knowledge of the cares to
be taken when operating the machine , carefully reading all this Instruction Manual .
4.1 Basic Operation Procedures
4.1.1 Dangers
Some parts of the machine electrical commands have high voltage points or
terminals . These when touched , may produce high electric shocks , and even
DEATH .
Never touch a manual command ( bottom , electric switch etc ) with wet hands ,
shoes or clothes. If this warning is not understood electric shocks and even DEATH ,
may occur .
4.1.2 Warnings
The Switch ON/OFF position must be well known , to allow it to be used without to
look for it .
Before proceeding to any maintenance , unplug the machine from the electric
network .
Provide enough space around the machine to avoid falls .
Water and oil may produce a dangerous and slippery floor . To avoid accidents the
floor shall be dry and clean .
Never use a manual command ( button , switch , lever , etc ) unadvisedly .
If any work has to be done by more than one person , coordination signs shall be
accorded , for each step of the work . Next step shall not be started without the sign
is given and acknowledged .
7
IMPORTANT
If any item from the GENERAL SAFETY NOTIONS section is not
applicable to your product, please disregard it.
That is why such products must not be used for cleaning and sanitization.
Scrapings made with sharp instruments or similar must also be avoided.
Main substances that cause stainless steel corrosion:
Dust, grease, acid solutions such as vinegar, fruit juices, etc., saltern
solutions (brine), blood, detergents (except for the neutral ones), common steel
particles, residue of sponges or common steel wool, and also other abrasives.
Summary of Contents for CS
Page 2: ......