B.Well PRO-33, Instructions For Use Manual

Page: 9 / 83

Instruction for use
9
En
PRO-33 / PRO-35
14. The monitor might not meet its performance speci fi cations or cause safety hazard if stored or used
outside the speci fi ed temperature and humidity ranges in speci fi cations.
15. Please do not share the cuff with other infective person to avoid cross-infection.
16. Please note that changes or modi fi cations not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
17. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular instal-
lation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
18. If this complete set did not switch on the mains adapter, it can be got separately. Use only the adapter AD-155. The AC adapter which
output is DC 6.0V 600mA and complied with IEC 60601-1/EN 60601-1/UL 60601-1 and IEC 60601-1-2/EN 60601-1-2/UL 60601-1-2.
Shouldn’t use the another adapter model.
7. SETUP AND OPERATING PROCEDURES
7.1. Battery loading
a. Open battery cover at the back of the monitor.
b. Load four “AAA” size batteries. Please pay attention to polarity.
c. Close the battery cover.
d. Once you install the batteries or turn off the monitor, the LCD does not display anything. Now the monitor is in Off.
Only for model PRO-33:
If the LCD displays battery symbol , while the monitor is on, the batteries are running out.
If the batteries are run out, battery symbol will blink for 10 seconds.
Then the monitor will always display battery symbol and cannot open.
Please replace all batteries with new ones.