12
STOP
STOP
STOP
5 Inspection before the first use
7 Instructions for use
6 Daily inspection
The detailed installation procedure of the flange connection
kit is available upon request to AVANTI.
Before the first use, a certified technician shall inspect
the FPS.
The inspection before the first use shall be carried out following the
inspection procedure. During the inspection, the “Annual Inspection
Checklist” Appendix and the “Inspection log sheet” Appendix shall be
filled in for future reference.
a) Before using the runner, perform a daily inspection following the “Daily Inspec-
tion Checklist for Runner 2000/2002” Appendix or the “Daily Inspection
Checklist for EagleDS Runner” Appendix. If any of the checks does not pass,
the runner system cannot be used.
b) During the ascent, look for visible damages or loose parts such as loose screws
on ladder, rail or joints.
c) Equipment with defects or equipment that leaves doubt concerning safe use
must be checked by a certified technician.
Do not use the FPS if it looks defective or if parts are missing.
If the FPS has blocked a fall or has been put out of service
because of doubts, it may only be put back to service after an
inspection by a certified technician is performed. The certified
technician shall confirm in writing that the FPS is found in safe
condition to be used again.
The Avanti fall arresters could be lubricated with a high perfor-
mance grease, for instance HTS+PTFE ABSOBON (Würth), for
cold conditions. Any grease to be used in Avanti fall arresters
must be verified and approved by Avanti.
7.1 Instructions for use of Runner 2000/2002
7.1.1 Attaching the Runner 2000/2002 to the safety rail
Before using the runner, make sure that you are wearing an
approved full body harness, and that it is properly adjusted to a
snug fit (it should not be used if loose). Before attaching the
runner to the rail, ensure that you are in a safe area (ground level)
or attached to an alternative fall protection.
Before attaching the runner to the rail, ensure that it is attached to the
D-ring marked “A” of the full body harness in order to avoid dropping it.
The carabiner shall only be connected to the D-ring marked “A” of
the full body harness located on the front side of the user and located
at the chest height.
The D-ring marked “A” shall comply with the demands for climbing in
vertical fall arrest safety systems on ladders (see the user´s manual of
the full body harness).
When attaching the carabiner, ensure that the shock absorber is
not twisted between the runner and the carabiner. A twisted shock
absorber may cause the FPS to fail.
a) Place the runner on the
safety rail ensuring that the
arrow on the plate of the
runner points upwards.
Otherwise, the runner will
not arrest a fall.
Flange connection kit
MASTER 47840008 EN_CORREGIDO.indd 12
25/10/17 12:01
