ROOFERS KIT
USER MANUAL
www.bsafe.com.au
1300 783 606
18
I
Product:
Date of Manufacture:
Withdraw from Service
Report No:
Serial No:
Component
Condition of fault to be checked
Checked
Webbing
Cuts or Tears
Abrasion damage especially where there is contact w/ hardware
Excessive stretching
Damage due to contact with heat, corrosive or solvents
Deterioration due to rotting, mildew or ultraviolet exposure
Snap Hooks &
Karabiners
Distortion of Hook or Latch
Cracks or forging folds
Wear at swivels and latch pivot pin
Free movement of latch over its full travel
Broken, weak or misplaced latch springs
Free from dirt or other obstructions
D Rings
Excessive vertical movement of the straight portion of the D Ring at its attachment point
on the belt, so that the corners between the straight and curved sections of the D become
completely exposed
Cracks, especially at the intersection of the straight and curved portions
Distortion or other physical damage of the D ring
Excessive loss of cross-section due to wear
Buckles &
Adjusters
Distortion or other physical damage
Cracks and forging laps where applicable
Belt Tongues
Open Rollers
Sewing
Broken, cut or worn threads
Damage or weakening of the threads due to contact with heat, corrosives, solvents or
mildew
Ropes
Cuts, abrasion or fraying
Stretching
Damage due to contact with heat, corrosives, solvents, etc
Deterioration due to ultra violet light or mildew
General Comments
Final Appraisal:
PASS:
FAIL:
INSPECTOR
INSPECTOR
DATE:
DATE:
ROOFERS KIT
INSPECTION CERTIFICATE
(IN ACCORDANCE WITH
AS/NZS 1891.5 &
AS/NZS 1891.4)
CLEANING OF HARNESS: If soiled by dirt or grit, sponge down or hand wash with luke warm tap water using pure soap or soap flakes. Thoroughly rinse and hang harness to
dry at room temperature out of direct sunlight and not exposed to direct heat. If any other condition exists consult inspection guide in operational instructions or contact your
nearest Beaver Branch.
