06
05
1. Remove all packaging and clean all removable
parts and the grooves of the product with a
soft, dry cloth.
2. Make sure the power sockets and extension
units meet the requirements of the product.
Make sure the product connects to the
power supply before use.
3. This product is equipped with a sensor to
monitor the position of the filter unit. If the
filter unit is not in the correct position, the
product will not work.
4. It is normal for the product to emit warm air
with a mineral smell from the air outlet when
the product first works. It is because the
catalytic oxidation reaction is going on inside
the NCCO Reactor.
Installation Procedures:
1
2
Unplug the appliance, find the two grooves
under the front panel, and remove the front
panel by pulling it outward.
Illustration Diagram:
Basic Information
Main Parts & Components
First Time Use
Install the NCCO Reactors into the device.
There is a click sound to indicate installation
successfully.
Install HEPA filter, static filter and pre-filter in
sequence into HEPA filter frame.
Remove all packaging before use.
Pre-filter
Power Cord Inlet
Power Cord
Control Panel
Air Inlet / Front Cover
HEPA Filter
and Filter Frame
NCCO Reactor
Unit Body
Right Air Outlet
Left Air Outlet
Static Filter (Optional)
Power Cord Coupling
3
4
Getting Started
Summary of Contents for BM300
