40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
RELEASE DATE
12/21/2021
REFERENCE NUMBER
INS-2701-00
2. Connect conduit to the 3/4” primary conduit
couplers attached to the bottom of the PVC
housing. Place PVC housing in hole.
3. Prep for concrete. Base is flush with finished
grade.
4. Pull branch circuit wiring necessary for
appropriate installation.
1. Excavate trench according to designed lighting
plan. Dig hole a minimum of 24” deep and
10” wide to accommodate PVC housing at
desired fixture location and direction of in-use
receptacle(s).
Finished grade
Pea Gravel
or Sand
Concrete
Finished Grade
GRADE
GRADE
Finished grade
Pea Gravel
or Sand
Concrete
Finished Grade
GRADE
GRADE
Finished grade
Pea Gravel
or Sand
Concrete
Finished Grade
GRADE
GRADE
PVC HOUSING MUST BE INSTALLED AS PER GRADE LABEL. HOUSING IS LABELED AT GRADE
LEVEL. HOUSING INSTALLED BELOW GRADE WILL VOID WARRANTY
Align holes
for screw
orientation
3. Prepare epoxy (included) according to
instructions on packaging.
INSTALLATION OF BASE
6. Place base onto epoxyed PVC housing over
steel plate, lining up with steel plate mounting
holes and drilled mounting holes in concrete.
4. Use mixing stick to apply the epoxy to the
exterior of exposed PVC housing as shown, in
smooth, continuous application.
1. Steel plate and base has four (4) 5/16” dia. holes
at 3” square on center for mounting hardware.
Use steel plate as template for final mounting
drill hole positions.
2. Drill four (4) holes into concrete for minimum 1/4”
sleeve or wedge anchors for concrete. Clean or
vacuum debris from drilled holes.
Minimum of 1/4” dia. anchors must be used.
5. Place steel plate epoxyed PVC housing, lining
up with drilled mounting holes in concrete.
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
Receptacle Bollard
Installation Instructions
INSTALLATION OF PVC MOUNTING
