B-K lighting Precision2 HP2 Series Installation Instructions Download Page 4

Page: 4 / 5

RELEASE DATE

12-11-16

REFERENCE

NUMBER

INS001399

40429 Brickyard Drive • Madera, CA 93636 • USA

559.438.5800 • FAX 559.438.5900

www.bklighting.com • [email protected]

B-K LIGHTING

IMPORTANT SAFETY INFORMATION LISTED ON REVERSE

READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS

SERIES

Solid State LED with Color Tuning

Installation Instructions

For Optional Accessory Holder:

Gently press

accessory holder downwards over optic on

OptiLock® .

10. Aim fixture by adjusting OptiLock® assembly

with Phillips screw driver.

11. Remove any dirt or debris in O-ring groove near

top of housing. Place O-Ring inside of groove.

Failure to clean groove of debris will cause

fixture to fail and void product warranty.

12. Install faceplate using 1/8” Allen wrench and

hand-tighten the faceplate screws in a star

pattern to 30 in-lbs. min.

Do not use a power tool to install screws. Do

not exceed 40 in-lbs.

Summary of Contents for Precision2 HP2 Series





