PROJECT:
TYPE:
CO
2
SERIES
Integral - Standard/Offset Metal Halide (ES16)
Ballast Installation Instructions
RELEASE DATE
7-13-16
REFERENCE
NUMBER
INS-1382-00
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
13. Remove any dirt or debris in O-ring groove near
top of housing. Place O-Ring inside of groove.
Failure to clean groove of debris will cause
fixture to fail and void product warranty.
14. Install faceplate using 1/8” Allen wrench and
hand-tighten the faceplate screws in a star
pattern to 30 in-lbs. min.
Do not use a power tool to install screws. Do
not exceed 40 in-lbs.
10. Place OptiLock® in CO2 housing and align
keyhole notch under one of (3) #8 screw heads.
Rotate horizontally to desired aiming position,
then tighten (2) #8 Phillips screws using Phillips
screwdriver. Install proper ES16 metal halide
lamp.
9. Connect secondary leads from ballast to
OptiLock® leads using pre-wired factory quick
disconnect.
11.
For Optional Accessory Holder:
Insert
accessory holder tabs into slots on OptiLock®.
12. Aim vertically by turning the thumbscrew on
OptiLock® assembly.
