120V
12V
FIXTURE
COM
GROUND
WIRING DIAGRAM
Transformer
COM
GROUND IN T-HOUSING
120V
12V
LAMP
COM
GROUND
Transformer
COM
GROUND IN T-HOUSING
WIRING DIAGRAM
Phase 2 - Finish Installation of Fixture with Power Canopy.
1. Remove one or two wire entrance knockouts on
wall plate. Pull primary branch circuit through
knockout(s). Attach wall plate to junction box
using appropriate hardware (By Others).
2. Ground primary branch circuit to wall plate
per NEC. Make connections from transformer
to primary branch circuit using proper
wire connectors. (By Others) (By Others).
See wiring diagram.
3. Connect fixture to transformer with provided
quick disconnect.
4. Mount canopy to wall plate using four (4)
#8-32 stainless steel button head screws with
5/64” Allen wrench. Seal building envelope
as per NEC. Do not overtighten.
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
RELEASED
7-25-18
REFERENCE
NUMBER
INS-2249-01
Phase 1 - Rough In
Installation of Back box
1. Install Conduit, Junction Box (By Others) to be
used with this product.
2. Install junction box so that front face is flush
with finished wall or ceiling. Seal building
envelope as per NEC.
3. Connect box to conduit and pull wires for
connections (See Wiring diagram).
Additional Info
• Please follow National and Local electrical codes for your area.
• Junction box installation must be designed to hold full fulcrum weight
of fixture.
• Junction box, universal mounting ring screws, box mounting hardware
and gaskets (By Others)
TWIN SIGN STAR™
Mini-Micro™ Series on Power Canopy™
5. Use 5/32” Allen wrench to loosen #10-32 stainless
steel black oxide socket head cap screw at the
knuckle. Aim fixture to desired vertical location.
Tighten to secure aiming position.
