IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
Standard Instructions
HP2
INTEGRAL TRANSFORMER - STANDARD MR16 & PAR36/AR111
RELEASE DATE
08/28/2023
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
REFERENCE NUMBER
INS-2858-00
9. Connect secondary leads from transformer to OptiLock
leads using pre-wired factory quick disconnect.
FOR USE WITH MR16
11a. Aim vertically by turning the thumbscrew on
OptiLock assembly.
FOR USE WITH PAR36/AR111
11b. Aim vertically by turning the #10 phillips head screw
on OptiLock assembly with phillips screwdriver.
FOR USE WITH PAR36/AR111
12b. Turn accessory holder upside down and remove
retainer clip. Insert up to two (2) accessories.
Insert the retainer clip back on.
Insert any accessory lens with the smooth side
towards the lamp. If using a honeycomb baffle,
position it farthest from the lamp.
FOR USE WITH MR16
12a. Turn accessory holder upside down and remove
retainer clip. Insert up to two (2) accessories.
Insert the retainer clip back on.
Insert any accessory lens with the smooth side
towards the lamp. If using a honeycomb baffle,
position it farthest from the lamp.
10. Place OptiLock in HP2 housing and align keyhole
notch under one of three (3) #8 screw heads. Rotate
horizontally to desired aiming position, then tighten
two (2) #8 phillips screws using phillips screwdriver.
Install proper MR16 halogen or PAR36/AR111 lamp
according to instructions on Lamp Installation or
Re-Lamping page.
OptiLock vary by product.
6. Lower transformer assembly into HP2 housing.
7. Line up transformer plate to posts inside the HP2
housing with slots as shown.
8. Secure transformer plate into place by tightening
the three (3) #6-32 screws against the posts using
a 5/64” ball driver.