40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
5. Mount faceplate using two (2) #10-24 screws with
1/8” Allen wrench. Tighten to compress gasket. Do
not over tighten.
Phase 2 - Finish Installation of Fixture with Remote Transformer
1. Remove #10-24 Phillips screws from mounted back
box. Install universal mounting ring (supplied with
faceplate) using #10-24 screws onto back box.
Align faceplate mounting holes to final mounting
position.
Phase 1 - Rough In
Installation of Back box
1. Install Conduit (By Others) to be used with
this product.
2. Install junction box so that front face is flush
with finished wall or ceiling.
3. Connect box to conduit and pull wires for
connections (See Wiring diagram).
Additional Info
• Please follow National and Local electrical codes for your area.
• 4” round cast box
• Suitable for through wire.
• Suitable for installation into combustible materials.
• Rated for 90° C.
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
RELEASED
7-13-16
REFERENCE
NUMBER
INS-1496-TP
BACK BOX
Low Voltage Halogen - Thermal Protector
Installation Instructions
Red
LAMP
QUICK
DISCONNECT
REMOTE
TRANSFORMER
THERMAL
PROTECTOR
LINE
C
OMMON
Red
White
White
Yellow
Whit
e
Whit
e
Whit
e
Black
2. Make watertight connections from remote
transformer to thermal protector using
waterproof wire connectors. (By Others)
See
wiring diagram.
WIRING DIAGRAM
Low Voltage - For use with 12VAC remote
transformer.
3. Connect quick disconnect from thermal protector
to lamp leads.
4. Re-insert socket assembly into faceplate.