![background image](http://html1.mh-extra.com/html/b-k-lighting/artistar-uplight/artistar-uplight_installation_3096775002.webp)
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
RELEASE DATE
07/11/2023
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
REFERENCE NUMBER
INS-2862-00
Standard Installation
ARTISTAR UPLIGHT
SURFACE MOUNT
9. Mount faceplate to collar using two (2) #8-32 flat head
screws (included) with a 9/64” allen wrench.
WIRING DIAGRAM
LED - For use with 12VAC LED remote transformer
or magnetic transformers only. B-K Lighting
cannot guarantee performance with third party
manufacturers’ transformers.
4. Align holes to final installation orientation. Arrows
on temporary cover point towards screw location on
faceplate for alignment purposes.
NOTE: Do not remove temporary cover until
installation of faceplate.
6. Remove temporary cover and pull out remote wiring.
4” O.D.
4-1/2” O.D.
2. Loop minimum of 6” of wiring inside housing to allow
for fixture service.
NOTE:
Do not remove temporary cover!
Finished grade
Wire nuts must
clear opening
6”
min.
Screws on faceplate will
align with alignment
arrows on temporary
cover
7. Access remote wiring inside housing. Make watertight
connections using waterproof wire connectors. Wire
nuts must clear opening. Insert fixture, wiring and
connections into housing.
See wiring diagram.
5. Use a silicone based sealant between fixture and
mounting surface.
1. Drill 4” diameter hole into mounting surface at uplight
installation location as per lighting plan.
Do not exceed surface diameter, installation relies
on surface mount collar resting on surface grade.
Collar diameter is 4”. Surface mount flange is 4-1/2”
diameter
Pull secondary wiring from remote driver.
3. Place housing into hole. Surface mount collar should
rest on finished surface grade.
NOTE:
Do not remove temporary cover!
HOT
12V
12V
FIXTURE
NEUTRAL
Remote
Transformer