![background image](http://html1.mh-extra.com/html/b-k-lighting/artistar-remote-es16-metal-halide/artistar-remote-es16-metal-halide_installation-instructions-manual_3095244002.webp)
8. Tighten the three (3) #8-32 stainless steel set
screws on anchor base and 1/4”-28 stainless
steel locking screw at the knuckle to secure all
aiming positions.
6. Place fixture onto mounted anchor base and
press straight down until the two pieces are
flush with each other.
7. Use 3/16” Allen wrench to slightly loosen
¼”-28 stainless steel black oxide socket head
cap screw at the knuckle for vertical aiming
purposes. Rotate fixture at base and aim fixture
to desired horizontal location.
WIRING DIAGRAM
LINE
(+)
FIXTURE
COM
WIRING DIAGRAM
REMOTE
POWER
SUPPLY
(-)
GROUND
GROUND
RELEASED
1-26-16
REFERENCE
NUMBER
INS132000
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
THIS DOCUMENT CONTAINS PROPRIETARY INFORMATION OF B-K LIGHTING, INC. AND ITS RECEIPT OR POSSESSION DOES NOT CONVEY ANY RIGHTS TO REPRODUCE, DISCLOSE ITS CONTENTS, OR TO MANUFACTURE, USE OR SELL ANYTHING
IT MAY DESCRIBE. REPRODUCTION, DISCLOSURE OR USE WITHOUT SPECIFIC WRITTEN AUTHORIZATION OF B-K LIGHTING, INC. IS STRICTLY FORBIDDEN.
1. Study anchor base plan. Prepare mounting
surface for anchor base.
2. Use 5/64” Allen wrench loosen three (3) #8-32
stainless steel set screws (do not remove set
screws from fixture base). Remove anchor base
from bottom of fixture.
4. Secure anchor base to solid surface (i.e. wood,
concrete) using appropriate hardware for
specific surface.
5. Make two connections from remote ballast
housing to fixture leads using proper wire
connectors (By Others). Connect incoming
ground wire to ground wire provided in fixture
body. See wiring diagram.
3. Pull wires from remote ballast housing
necessary for installation (By Others). Feed
wiring through anchor base.
All line voltage connections must be
made in compliance with the National
Electrical Code. Failure to do so will void
warranty.
ArtiStar™ Remote
ES16 Metal Halide
Installation Instructions