16
DIAMOND3
®
675TS
GB
• Release the transportation lock.
Cooling system
NOTE:
Operating the water pump with-
out a sufficient supply of water
may result in pump damage.
• Place the plug in the drain of the water
container .
• Fill up the container with water until
the water pump is submerged till the
pumpgrip .
Connecting to power supply
First, check whether:
• the line voltage corresponds with the
data on the machineís specifications
plate,
• there is a grounded power supply,
• the extension cord wire cross-section is
at least 1,5 mm
2
.
Motor protection
The motor is equipped with a thermal
safety switch for protection against an
overload . When the motor gets over-
heated, the switch falls back into its initial
position and can only be switched on
again after the motor is cooled down . The
switch also protects against power failure .
When the power returns, the motor will not
start on its own but must be switched on
by hand .
Installing the saw blade
WARNING:
Make sure to disconnect the
machine from the power supply
before fitting or switching the
saw blade or when doing any
maintenance on the machine.
• Remove saw cover.
• Block the sawing spindle with wrench
20 .
• Unscrew the hexagon nut with wrench
46 and remove the saw flange .
(Attention: Left-handed screw thread.)
• Clean the saw flanges.
• Fit the saw blade on the motor shaft.
(Check the direction of rotation and
make sure the blade is well centred.)
• Mount saw flange and tighten with
the hexagon nut. Place saw cover and
tighten with the 4 knobs .
7. SAWING PROCES
(Use only original saw blades as advised
by the manufacturer .)
• Place the material to be cut on the
sawing table and position against the
fixed stop.
• Push the sawing table forward with
controlled feed so that the sawing
blade is easy cutting through the mate-
rial .
8. SAFETY
Besides the valid safety regulations atten-
tion to the following items should be made:
• Carefully follow the directions of set-
ting up and working with the sawing
machine .
• Carefully check that the electrical con-
nections are correct .
• Electrical cables should not come in
contact with water or water spray .
• Damaged saw blades should be
replaced immediately . Check the saw
blade cover .
• Secure material to be cut by hand dur-
ing sawing .
• Make sure your hands stay away as
far as possible from the rotating saw
blade .
