15
DIAMOND3
®
675TS
GB
tact with water or spray water .
• Damaged saw blades should be
replaced immediately .
4. ELECTRICITY AND SAFETY
WARNING:
On construction sites electrical
appliances should be connected
to specially designed power sup-
plies.
Suitable are grounded main power sup-
plies equipped with an earthleak switch of
max. 30 mA or separating transformers.
Non-grounded common household or simi-
lar power outlets are not suited as a power
source .
For water cooled sawing machines stricter
safety standards are applicable . Therefore,
for extra safety the machine must be con-
nected according to one of the following
methods:
• Main power supply equipped with
earthleak switch 30 mA
or
• Separating transformer, only 1 machine
may be connected at any given time
or
• With an intermediate cable equipped
with a PRCD safety switch of max.
30 mA .
5. CHARACTERISTICS
Machine construction
The stainless steel construction contributes
to a stable, rigid and durable sawing
machine . The saw table is equipped with
four stainless steel rollers with plastic bear-
ing bushes for smooth running and precise
saw guidance. The machine has fold-out
legs with two wheels for easy transport .
Saw head
The saw head is constructed of welded
steel components . This is provided with an
eye in order to be able to lift the machine,
without the cooling water in the water
container .
Saw cover
The saw cover is a welded steel plate
cap, simple to remove and install for
changing the saw blade by unscrewing 4
knobs .
Saw spindle
The motor flange is mounted on the saw
spindle . The saw flange is to be mounted
on the saw spindle with a hexagon nut
to clamp the saw blade .
(Attention: Left-
handed screw thread)
Saw table
The saw table is constructed of welded
stainless steel components, equipped with
adjustable side stop .
Cooling system
The electric water pump can only be
turned on with the switch under the saw
motor On/Off switch when the saw motor
is on . The water pump supplies cooling
water to the saw blade . A drain hole, with
a plug, is located in the water container .
Mud flaps prevent most of the water mist
and make sure most water flows back in
the water container .
The water pump can be switched off for
external water supply.
6. UNPACKING AND SET UP
Setting up
• Unpack the sawing machine and
inspect for any damaged parts .
• Unfold the legs completely, slide them
up and secure with the knurled knobs .
• Level the sawing machine by adjusting
the legs in the sockets and make sure
its stable .
